WrapStand® Wrap and Bag Caddy FAQs

Instructions

How to Assemble: 

1. Insert one side of a wire holder into the lowest slot of the base. Squeeze the other side of the wire towards the center and insert into the opposite side of the base. IMPORTANT: Make sure the wire “feet” are facing down and the rounded part is facing up.
2. Repeat on the other side so the base is balanced and stands on a flat surface.
3. Load your heaviest kitchen wrap onto the bottom wire holder and insert another wire above the box in the same manner as before. You’ll want to leave enough space to remove and replace the wrap as needed. For a bag dispenser, place the wires as close to the box as possible in order to trap it in place. Make sure to position the bag opening so it’s facing out.
4. Repeat this process with remaining wires.

CARE INSTRUCTIONS:  Wash by hand with lukewarm water and mild soap; NOT dishwasher safe.

What size is the WrapStand?

#50173

How many boxes does the WrapStand hold and what size boxes does it fit?

The WrapStand fits 4-8 boxes and was designed to fit in standard cabinets or the pantry. It includes 8 adjustable wire holders that fit boxes that measure up to 3” (7.6 cm) wide. Large or jumbo boxes may not fit properly.

What is the WrapStand made of?

The WrapStand base is made of durable ABS plastic that wipes clean with a damp cloth. The wire dividers are made of steel with a power-coat finish. Soft vinyl feet prevent the unit from sliding around inside the cabinet. No assembly is required other than placing the dividers as needed.